Do you know how to use automatic pill making machine? |
|
2023-5-31 publish |
Do you know how to use automatic pill making machine?
Automatic shot making machine is suitable for ambient temperature -5℃ to 40℃, relative humidity is less than 90%, grid voltage amplitude fluctuation <10% rating, no conductive dust and corrosive metal gas around the room. Installed in the sunny clean plant, can not use the foundation, flat pad, for safety must be grounded wire.
Check whether the oil level of the transmission reaches the standard position before starting the automatic Chinese medicine pill making machine; Check whether the shot making machine is aligned and tightened; The discharge system should be smooth and adjusted. The guide wheel, guide frame and pill making knife should be disinfected with alcohol.
The outlet part of the empty operation for 3-5 minutes, no abnormal can feed, push out the bar. Return to the hopper part, and open the shot making part after the material bar is qualified. The feeding should be uniform in operation. If it is found that the strip is out of sync with the pill making, it can be adjusted by the knob. Clockwise pill making is fast and anticlockwise pill making is slow. The size of the shot diameter can be achieved by changing different outlet and shot roller and guide wheel.
When feeding, foreign matter shall not be put into the hopper. Do not extend your hand into the upper plane of the hopper, so as to avoid the hand injury of the press plate. It is necessary to check regularly whether there is any abnormality in each part of the machine.
We shut off the main switch and other switches after use. When cleaning, first remove the outlet, heating cover, unloading the machine head, can be used hook plate hand (special), and then pull out the support and propeller.
The oil in the reducer should be kept on the oil label. The waste oil should be discharged and the new oil should be replaced during normal operation from two to May. The appropriate amount of oil should be added to the other gears and sprockets.
|
|
|